Pilates Spring Board Installation

Installation Tips

1. Measurements:

Height: 1820 mm = approximately 71.65 inches.

1. • Width: 555 mm = approximately 21.85 inches.
   • Distance between screws at the bottom bar: 800 mm = approximately 31.5 inches.

2. Wall Mounting Instructions:

   • Use 4 long screws for the top and bottom holes on the board.
   • Use 2 short screws for the middle section.
   • Mount the board 10–15 cm (approximately 4–6 inches) off the ground.

3. Important Notes for Installation:

   • Ensure the wall is a load-bearing wall to support the equipment securely.
   • Locate wall studs using a stud finder to ensure that screws are fastened into solid support, not just drywall. If studs are not available in the right locations, use heavy-duty wall anchors capable of handling the weight and tension from the equipment.
   • Verify the wall’s ability to hold both the board and the force applied during use.

4. Additional Precautions:

   • After installation, check the stability by gently pulling on the equipment.
   • Periodically inspect the screws and anchors to ensure they remain secure over time, especially after heavy use.

This installation process ensures the equipment is safe and properly mounted for use. Let me know if you need further assistance!