PERSONALHOUR INSTALLATION GUIDE
Napolie Plus Installation Guide
Follow this step-by-step guide to safely assemble your Napolie Plus Pilates Reformer. This walkthrough includes the frame setup, tower installation, spring connections, accessories, and safety recommendations.
Installation Video
Watch the full installation video before starting assembly. We recommend following the video together with the written steps below for a smoother setup process.
Important Safety Notice
Please verify all parts before installation. If any component is missing or damaged, stop assembly and contact PersonalHour support immediately.
This machine should only be used with proper understanding of Pilates equipment safety. Use carefully and preferably under qualified instructor guidance.
Included Parts
Vertical Pole × 6
Horizontal Tube × 4
Trapeze Table × 1
Single Loop Handle × 2
Spring Set × 10
U-shaped Bar × 1
Aerial Trapeze × 1
T-Pin × 2
Safety Rope × 1
Plush Handle × 2
Barrel Base × 4
Barrel × 4
Conversion Plate × 1
Step 1 — Check All Parts
01
Open the Package Carefully
Open all packaging materials and confirm all parts are included before beginning assembly. Organize the hardware and tubes in a clean open area for easier installation.
Step 2 — Frame & Barrel Setup
02
Install the Conversion Plate
Place the conversion plate onto the body frame and align it securely.
03
Attach Barrel Bases & Barrels
Install the barrel bases and barrels onto the bed legs and secure them using the included screws.
04
Install Vertical Poles
Attach the vertical poles onto the barrel sections carefully and verify all poles are aligned properly.
05
Install Horizontal Tubes
Mount the horizontal tubes onto the vertical poles using the 90° corner connections.
Step 3 — Upper Frame Assembly
06
Install Straight Clamp Tubes
Attach the straight clamp style horizontal tubes to the opposite side of the frame.
07
Connect Top Frame Sections
Secure the top frame using the remaining horizontal tubes and longest vertical poles.
08
Align All Corners
Ensure all corners are level and aligned before tightening the structure fully.
Step 4 — Push-Through Bar & Springs
09
Tighten the Frame
Tighten all four corners using the included screws and tools.
10
Install the U-shaped Bar
Secure the U-shaped push-through bar using the included T-pins.
11
Attach Springs
Install the yellow and purple springs between the body frame and push-through bar.
12
Install the Safety Rope
Thread the safety rope through the push-through bar and attach it securely to the frame spring loops.
Step 5 — Final Accessories & Handles
13
Install Aerial Trapeze Springs
Connect the blue springs between the frame loops and aerial trapeze.
14
Attach the Trapeze Table
Use the red springs to connect the trapeze table to the middle horizontal bar.
15
Install Plush Handles
Attach the plush handles securely to the vertical poles.
16
Install Single Loop Handles
Attach the yellow springs from the bar loops to the single loop handles.
Before First Use
- Double-check all screws and frame connections.
- Confirm springs are connected securely.
- Inspect the push-through bar safety rope.
- Test the carriage movement slowly before exercising.
- Use the reformer only on a stable and level surface.
